Stovax Ceramica Coal Effect Stove Range Conventional Flue User Manual

CeramicaCoal Effect Stove RangeConventional FlueWith upgradeable control valveInstructions for Use,Installation and ServicingFor use in GB, IE (Great

2.7 The stove is fitted with the Gazco Flue Sure System, whichacts to cut off the gas supply to the appliance in the eventof incorrect operation of th

113.5 Remove the assembly and drill the two holes using a No. 12masonry bit. Push the rawl plugs into the holes, and placethe engine assembly in posit

123.9 Place the flame baffle onto the shelf at the rear of the trayand push up against the rear ledge, see diagram 7.3.10 Locate the front coal mouldi

133.15 Place the top ceramic panel into position so that the twospring clips slide against the inside of the side panels, gentlyposition so that it si

14INSTALLATION INSTRUCTIONSCOMMISSIONING1.1 Close all openable doors and windows in the room. Ignitethe stove and operate on maximum for 10 minutes. P

15IGNITION FUNCTIONAL CHECK 1PILOT WILL NOT LIGHTEnsure there is no debris around the pilot assembly, (e.g. soot, etc.) which could short the spark, c

16PILOT WILL NOT STAY LIT OR FIRE GOES OUT IN USEEnsure there is no debris around the pilot assembly, e.g. coal, soot etc. which could short the spark

17This should allow full access to all major components.2.1 Turn the gas supply off at the isolation device. Ensure theunit is cool.Use cover material

2.3 Loosen main injector nut on airbox and disconnect frominjector, see diagram 6, A.2.4 Remove the 2 screws attaching burner to back of unit, seediag

SERVICING INSTRUCTIONSREPLACING PARTS4.1 Gain access to the back of the pilot assembly, (see section2) and disconnect the ignition lead from the elect

2CONTENTSCOVERING THE FOLLOWING MODELS:CERAMICA MANHATTAN 8578-P8578PAGEAPPLIANCE COMMISSIONING CHECKLIST 3USER INSTRUCTIONS 4INSTALLATION INSTRUCTION

206.5 Disconnect the ignition lead from the gas valve.6.6 Undo the two bolts securing the gas valve to the applianceand remove the valve.6.7 Replace i

11.1 In order to change between gas types, it will be necessaryto change the following items.• Pilot Unit• Control Valve• Main Injector• Aeration Plat

22SERVICE RECORDS1ST SERVICEDate of Service:...Next Service Due:...

Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JGTel: (01392) 261999 Fax: (01392) 444148 E-mail: [email protected]

3APPLIANCE COMMISSIONING CHECKLISTDealer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1.12 In all correspondence, please quote the appliance type andserial number which can be found on the databadge at therear of the stove.1.13 This pro

53.1 To turn the stove off, locate the control valve, turn the left-hand control knob until it points to off ( ). The mainburner goes out leaving the

6USER INSTRUCTIONS6.1 Place the flame baffle onto the shelf at the rear of the trayand push up against the rear ledge, see diagram 3.6.2 Locate the fr

13.1 Parts of this appliance become hot during normal use. It isrecommended that a suitable fire guard be used forprotection of young children and the

8INSTALLATION INSTRUCTIONSTECHNICAL SPECIFICATIONPacking ChecklistQty Description1 Stove1 Flue Blanking plate1 Flue In fill plate1 Coal set*1 Flame B

9INSTALLATION INSTRUCTIONSSITE REQUIREMENTS1.1 The chimney or flue system must comply with the rules inforce, and must be a minimum of 127mm in diamet