Stovax 8542-P8542 User Manual

Clarendon and AshdonCoal Effect Stove RangeConventional FlueWith upgradeable control valveInstructions for Use,Installation and ServicingFor use in GB

10INSTALLATION INSTRUCTIONSTECHNICAL SPECIFICATIONPacking ChecklistQty Description1 Stove1 Flue Blanking plate1 Flue In fill plate1 Coal set*1 Flame

11INSTALLATION INSTRUCTIONSSITE REQUIREMENTS1.1 The chimney or flue system must comply with the rules inforce, and must be a minimum of 127mm in diame

off the gas supply, this indicates there is insufficient fluepull. If this occurs a minimum of 10 minutes should beallowed before trying to relight. C

13There is a cutout in the RH rear leg to enable a directstraight connection to be made to the rear of the stove. Seediagram 3. A gas soundness check

145.6 Place the remaining three round coals behind the centrerow so that they touch the back panel, see diagram 9.5.7Ensure that the fibreglass seal o

155.12 Place five small coals along the rear of the flame baffle,resting against the rear ledge, see diagram 15.5.13Ensure that the fibreglass seal on

16INSTALLATION INSTRUCTIONSINSTALLATION5.17 Place three small coals at each end of the front coal so thatthey lean against the flame baffle and a fur

17INSTALLATION INSTRUCTIONSCOMMISSIONING1.1 Close all openable doors and windows in the room. Ignitethe stove and operate on maximum for 10 minutes.Re

18IGNITION FUNCTIONAL CHECK 1PILOT WILL NOT LIGHTEnsure there is no debris around the pilot assembly, (e.g. soot, etc.) which could short the spark, c

19PILOT WILL NOT STAY LIT OR FIRE GOES OUT IN USEEnsure there is no debris around the pilot assembly, e.g. coal, soot etc. which could short the spark

2CONTENTSCOVERING THE FOLLOWING MODELSCLARENDON - 8541 - P8541 / 8517 - P8517- 8542 - P8542 / 8518 - P8518- 8543 - P8543 / 8519 - P8519ASHDON - 8513 -

202.3 Loosen main injector nut on airbox and disconnect frominjector, see diagram 3, A.2.4 Remove the 2 screws attaching burner to back of unit, seedi

213.1 Remove the burner module as described in ServicingSection 2 above. Carefully cut the cable ties holding thethermocouple to the pilot pipe. Remov

226.1 Turn the gas supply off at the isolation device. 6.2 Disconnect the 2x8mm and 1x4mm gas pipe fittings at theback of the gas valve and also disco

238.1 Turn the gas supply off at the isolation device. Locate themain injector on the LH side of the airbox, undo thecompression nut and pull the pipe

24SERVICING INSTRUCTIONSREPLACING PARTS12. CONTROL UPGRADEComponents Small Medium LargeStove Stove StoveNG LPG NG LPG NG LPGPilot Unit PI0036 PI0037 P

25SERVICE RECORDS1ST SERVICEDate of Service:...Next Service Due:...

26

27

Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JGTel: (01392) 261999 Fax: (01392) 444148 E-mail: [email protected]

3APPLIANCE COMMISSIONING CHECKLISTDealer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1.11 Contact a competent service engineer to carry out relevantspillage checks etc. following home improvements afterinstallation of this stove (e.g.

53.1 To turn the stove off, locate the control valve, turn the left-hand control knob until it points to off ( ). The mainburner goes out leaving the

6USER INSTRUCTIONS6.1Place the flame baffle onto the burner and push up againstthe rear tray lip, see diagram 4.6.2 Locate the rear panel against the

76.7Ensure that the fibreglass seal on the back of the door is intact,locate the door on the four studs and slide back to the firebox.Secure in place

8USER INSTRUCTIONS6.13Ensure that the fibreglass seal on the back of the door is intact,locate the door on the four studs and slide back to the firebo

96.19Ensure that the fibreglass seal on the back of the door is intact.Locate the door on the four studs and slide back to thefirebox. Secure in place